ここから本文です
TWO:To return to shop processes in manufacturing. Material operated upon has to be often, sometimes continually, moved from one place to another to receive successive operations, and this movement may be either vertically or horizontally as determined, first, by the relative facility with which the material may be raised vertically, or moved horizontally, and secondly, by [64] the value of the ground and the amount of room that may be available, and thirdly by local conditions of arrangement. In large cities, where a great share of manufacturing is carried on, the value of ground is so great that its cost becomes a valid reason for constructing high buildings of several storeys, and moving material vertically by hoists, thus gaining surface by floors, instead of spreading the work over the ground; nor is there any disadvantage in high buildings for most kinds of manufacture, including machine fitting even, a proposition that will hardly be accepted in Europe, where fitting operations, except for small pieces, are rarely performed on upper floors.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:CHAPTER XXXVI. SCREW-CUTTING.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:It struck me always that as soon as something took place anywhere which might lead to disorder, the method adopted was as follows: first a fusillade in order to scare the inhabitants, secondly looting of numberless bottles of wine, and finally cruel, inhuman murders, the ransacking and the wrecking.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:Im pretty close to one of the richest men in America, he began. You see, we both enlisted in aviation units when the big war tore loose and got Uncle Sam mixed up in it. We were buddies, Atley and me. Well, after we came back I stayed in aviation, knocking around from control jobs to designing new gadgets like superchargers and all. But when he went to California and began to organize some passenger flying lines, I stayed East in a commercial pilots job.General von Buelow says here that he gave his consent to the shooting of about one hundred persons, but I can state with absolute certainty that there were about 400 victims. We must therefore assume that the other 300 were killed without his consent.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:There was a continuous coming and going at the bridge-command, for when I left the shrubberies a great many soldiers of high and low rank, with portfolios and documents, were waiting outside. The soldiers were to escort me back across the bridge, so that I might go on to Vis along the other bank.102
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.